A Novel Method for Periapical Microsurgery With the Aid of 3D Technology

A Case Report

Shangzhu Ye; Shiyong Zhao; Weidong Wang; Qianzhou Jiang; Xuechao Yang


BMC Oral Health. 2018;18(85) 

In This Article

Abstract and Introduction


Background Three-dimensional (3D) technology has gained wide acceptance in dentistry. It has been used for treatment planning and surgical guidance. This case report presented a novel treatment approach to remove cortical bone and root-end during periapical surgery with the help of Cone-Beam Computed Tomography (CBCT), Computer Aided Design (CAD) and three-dimensional (3D) printing technology.

Case presentation A 37-year-old female patient presented with a large periapical lesion of left maxillary lateral incisor and canine was referred for microsurgical endodontic surgery. The data acquired from a preoperative diagnostic CBCT scan and an intra-oral scan was uploaded into surgical planning software and matched. A template that could be used to locate root-ends and lesion areas was virtually designed based on the data and was fabricated using a 3D printer. With the guidance of the template, the overlying cortical bone and root-end were precisely removed by utilizing a trephine with an external diameter of 4.0 mm. The patient was clinically asymptomatic at a six-month follow-up review. One year after the surgery, the lesion was healing well and no periapical radiolucency was observed on radiographic examination.

Conclusions The digitally designed directional template worked in all aspects to facilitate the periapical surgery as anticipated. The root-ends were accurately located and resected. The surgical procedure was simplified, and the treatment efficiency was improved. This technique minimized the damage and reduced iatrogenic injury.